Assembling The Light Kit; Installing The Glass - Hunter Rhinebeck Installation Manual

Partially install two assembly
screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
Partially install two of the assembly screws
found in the bag. It does not matter
which two screw holes you choose.
Tab
Notch
Lift the cap and align
the notches in the globe
with the tabs in the lower
switch housing.
Ceiling Bracket Downrod

Assembling the LIght Kit

2 of 3
Light Kit Screw
bag
2 of 3
Short Light Kit
Screw
bag
Align the keyhole slots in the lower
switch housing with the two screws. .
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light fixture.
Note:
Fan style may vary.
Hanging Fan Wiring
Feed the wire plug through the
center hole of the upper switch
housing, then wrap keyhole
slots around the screws and
twist counterclockwise.

Installing the Glass

Attach the cap by lifting and
turning clockwise one third of a
full turn of the cap until it stops.
NOTE: Check to ensure
proper engagement.
Canopy Blades
bag
Insert the third screw, found
in the hardware bag, into
place and then tighten all three
screws.
bag
Turn the lower switch housing
counterclockwise until the assembly screws
are firmly situated in the narrow end of the
keyhole slots. Install the third screw and
tighten all three screws securely.
Light Remote Troubleshooting
1886
1 of 3
Light Kit Screw
1 of 3
Short Light Kit
Screw
8