Page 2
- All wiring must be in accordance with national and local electrical codes ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician. c.2 - Use only Hunter replacement parts. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 3
Here is what comes in your box: 1886 Hunter Pro Tip: We recommend that you pull everything out of the box and lay it out. We have grouped the drawn components below with the hardware you’ll need for those Do not discard the hardware bags or mix parts from parts.
A little more information on Angled Mounting: For optimum performance and appearance, a longer downrod should be used with your Hunter ceiling fan when installing on high or angled ceiling. If your ceiling is angled greater than 34° you will also need an Angled Mounting Kit.
You have two options for installation. Pick which one works best for your location. Remove any existing Hunter Pro Tip: bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box. The machine screws are the ones that came with your outlet box.
1886 Hanging the Fan NOTICE To prevent damage to fan, ALWAYS lift holding either the fan housing or the downrod. Place the downrod ball into the slot in the ceiling bracket. Ceiling Bracket Hanging Fan Wiring Installing Fan Body Blades Light Remote...
If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a qualified electrician. You are going to need these: Hunter Pro Tip: Here is how to connect the wires: 4 Wire Nuts (these are in the...
1886 Installing the Blades: Insert the blade into the blade slot. Repeat x5 Put the blade washers found in the hardware bag onto the blade screws found in the hardware bag. Then install Blade Screw the blade screws to secure each blade to the fan.
1886 Assembling the Light Kit 3 of 3 2 of 5 1 of 5 Short Light Kit Screw Light Kit Screw Light Kit Screw Partially install two light kit assembly screws, found in the Align the keyhole slots in the top of the light kit hardware bag, halfway into assembly with the partially installed assembly Feed the light wires through the hole in the...
1886 Preparing the Remote To access the battery compartment, remove the small Phillips head screw that Battery secures the battery door to Door the transmitter assembly. The battery should be installed with the positive (+) side up. Replace with a CR2032 battery when necessary.
Fan not showing up the English side of this manual. in the list? Pull down to refresh! Hunter Pro Tip: Need to install the app later? When ready, turn the wall switch off and then on. Wait three minutes before downloading the app.
Hunter instructions, accidental damage caused by the fan owner or related parties, Please do not ship your fan or any fan parts to Hunter. Delivery will be refused. modifications to the fan, improper or incorrectly performed maintenance or repair,...