List Of Setup Command; Details Of Command Settings - Sony MG10-P1 Manual

5-4-1. List of Setup Command

Command Setting item
SETUP Start parameter setup.
MODE Set the measuring mode.
P Set the preset value.
CH Set the comparator upper limit.
CL Set the comparator lower limit.
SCN Set the comparator set number.
REF Set whether the reference point is to be used or
not.
LCLR Clear the reference point setting (reference point
offset value).
STTERM Select the external start input function.
RSSEP Select the RS-232C data transfer format
(separator).
RSFORM Select the RS-232C output data format.
RSTRG Select the RS-232C trigger or internal timer.
SCALE Select the scale unit (mm/inch).
CLOSE Close the parameter setup.
MG10-P1 / MG10-P2

5-4-2. Details of Command Settings

ASCII code is used for all the commands. A command is terminated
C R C R L F C R
by " " or " " + " ". ("
. Select using communication setting switch No. 2. on main unit.
C R " + " L F
OFF : "
C R
ON : " "
. On the pages to follow, "3" and "4" are used to indicate the
value to be set.
. When inputting a setting, a numerical value inside the assigned
range must be selected: otherwise, the value will not be set.
. If no polarity (+ or _) is input, it will be construed as +.
[Data which is input ahead of the commands]
Data Selection range
Unit number 0 to F or *
Module number 0 to F or *
. 0 to F are hexadecimal numbers which are equivalent to 0 to 15
under the decimal system.
. * is used when the settings are to be established for all units or
all modules.
L F
": carriage return; " ": line feed)
" (factory setting)
Symbol used in
descriptions
1
2
23
(E)