Ultra Start 4500 Installation Manual page 5

Installation Guide
6 Pin Power Connector
Yellow Starter 30amp output
Green Heater 30amp output
Red 12 power 30amp input
Red 12 power 30amp input
Blue Ignition 1 30amp output
White Selectable 30amp output
14 Pin Connector
Yellow Re-Arm
Orange (-) Output
Brown Disarm
Red/White 3rd CH
White/Violet (-)Running
Green (-) Door
Purple (+) Door
Green/White Hood Pin
Pink Brake
Black Ground
Blue/White Tach
Blue Glow Plug
White Park Lights
Black/White Park Brake
4 Pin Connector Square
White/Green Channel 4
Black Dome Light
White/Blue Siren
Red Trunk Pin
4 Pin Connector Red
Green Door Lock
Red 12 Volts
Blue Door Unlock
Pink 2nd Unlock
3 Pin Connector White
Green (-) Disarmed
Pink Horn/ Chan.5
Blue (+) Disconnect
Jumper Selections
The jumpers control the output on the white wire from the
six pin harness. Place the jumpers in the above order to
change the output.
Note: The default setting is second ignition.
Back View Of Module
WIRING CONNECTORS
12volts during crank only.
12volts in accessory. Off during start.
Constant 12volt power at ignition harness.
Constant 12volt power at ignition harness.
12volts in ignition and start positions.
Jumper Selectable. See Page 5.
0.75sec Pulse With Lock And On Shutdown.
Negative While Locked - **Starter Program Mode.
0.75sec Pulse With Unlock And Before Start.
Trunk Release - Active When button 2 is held.
Negative Output While Running.
Negative Door Trigger Input - Manual Trans And Alarm.
Positive Door Trigger Input - Manual Trans And Alarm.
Negative Hood Pin Input - MUST BE CONNECTED!!
Positive Brake Input - MUST BE CONNECTED!!
System Ground Input - MUST BE CONNECTED!!
Tach Signal Input - MUST BE CONNECTED!!
Programmable Input - DIESEL ONLY. **Programmable.
Positive Park light Output - 10 Amp Max.
Negative Park Brake Input - Manual Transmission Models Only.
Programmable Output. Press buttons #1 and #3 See Page 9.
Negative Output For Dome Light Supervision.
Positive Output For Siren.
Negative Input For Trunk Pin Switch.
Door Lock Output - Programmable - See Page 8.
Low Current Output. Use With Voltage Inverter
Door Unlock Output - Programmable - See Page 8.
Door Unlock Output - Programmable - See Page 8.
Programmable Output. (-) when disarmed, when cranking and LED.
Programmable Output. Press buttons #2 and #3.
(+) Disconnect Or Instant Start Trigger.
Jumpers
Output on White wire Jumper position
Second Starter
Second Accessory
Second Ignition
3 2 1
Position 1
Position 2
Position 3
5