Table of Contents
Advertisement
OPERATIONS
Lock Doors And Arm The Alarm
1. Press and release Button #1 on the Remote Transmitter.
2. The park lights will flash and the siren will chirp one time.
3. The remote will beep once and the doors will lock.
4. The LOCK icon will appear on the LCD display of the remote.
5. The LED's on the antenna will start flashing within five seconds.
Unlock Doors And Disarm The Alarm
1. Press and release Button #1 on the remote transmitter.
2. The park lights will flash 2 times and the siren will chirp twice.
3. The remote will beep twice to confirm.
4. The doors will unlock.
5. The UNLOCK icon will appear on the LCD display of the remote
6. The LED's on the antenna will stop flashing within five seconds.
Trunk Release
1. Press and hold the Trunk Release button (Button #2) for three seconds.
2. The doors will unlock, continue to hold for another three seconds and the Trunk Release will
Activate. The Trunk Release will then be confirmed by 2 park light flashes.
3. The remote will beep once then beep twice to confirm the Trunk Release was activated. The
Trunk icon will then appear on the LCD screen for 5 seconds.
4. For safety reasons, the Trunk Release output will be disabled and will not activate when
ignition key is in the "On" position.
Car Finder Mode / Optional 5th Channel
Car Finder Mode.
1. Press and hold Buttons #2 and # 3 together for two seconds.
2. The system will flash the park lights and chirp the siren five times.
3. The remote will beep and display the systems current status.
5th Channel Activation (Must be programmed - see page 9 setting 6)
1. Press and hold Buttons #2 and # 3 together for two seconds.
2. The park lights will flash.
3. The 5th channel output will activate. The remote will beep and display the systems current
status.
Panic Mode
ACTIVATE PANIC MODE
1.Press Button #1 for three seconds.
2.The park lights will flash and the siren will activate.
PANIC MODE DISABLE
- Press Button #1 to disable the Panic Mode and lock the doors.
- Press Button #1 to disable the Panic Mode and unlock the doors.
Note: Panic Mode will stay activated until disabled by the remote transmitter.
4th Channel Activation - See Page 9 Setting 4
ACTIVATE Channel 4 (White/Green) Wire on 4 pin Connector
1.Press Buttons #1 & #3 together for 1-2 seconds.
2.The 4th Channel output will activate in either a pulsed, latched or as long as held format
depending on how the system is programmed in Program Mode 2, Setting 4.
Details available on page 9, Mode 4 (4th Channel)
14
Installation Guide
Advertisement
Table of Contents
