9-Installation - Haier HWM70-FD10829 User Manual

9.1 Preparation
Take the appliance out of the packaging.
Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen-
tally friendly manner.
9.2 OPTIONAL: Adjusting the bottom cover
board
When opening the package, you will find a bottom
cover (A) The board is used for reducing noise after
covering the bottom of the cabinet.
1. Lay the washing machine down to its side, port-
hole pointing upwards, bottom side towards op-
2. Place the bottom cover.Screw the bolts through
the four holes on the board on to the tub firmly.
9.3 Dismantle the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1. Remove the back cover (Fig. 9-3.1).
2. Remove all 4 bolts on the rear side and take out
plastic spacers (A) from inner side of the machine
(Fig. 9-3.2).
24
upright again.

9-Installation

1.
A
9-3.1
9.2
2.
3.
9-3.2
A