Maintenance; Cleaning - TurboChef C3 Owner's Manual

To help your oven remain clean and in good condition, follow the daily and monthly cleaning instructions provided
in this section. Any unexpected issues you may encounter when using the C3 oven can often be resolved by referring to
the troubleshooting information in this section prior to contacting your service representative.

CLEANING

Carbon and grease buildup will adversely affect the
cooking performance and life expectancy of certain
components of the oven. It is the operator's responsibility
to properly maintain this unit. Failure to maintain this
unit in a clean condition will void the warranty. For
cleaning supplies, please call Customer Service at
800.90TURBO or +1 214.379.6000.
WARNING: Use only TurboChef
Cleaner and TurboChef
any other cleaning products can damage critical
parts and will void your warranty.
Supplies and Equipment
:
S U P P L I E S
TurboChef Oven Cleaner - United States (103180)
®
o
TurboChef Oven Cleaner - International (103380)
®
o
TurboChef Oven Guard - United States (103181)
®
o
TurboChef Oven Guard - International (103381)
®
o
:
E Q U I P M E N T
Nylon 3x5" green scrub pads
o
Dry, clean towels
o
Firm bristle brush: 6-8" handle with 2x2x1 bristles
o
DO NOT use a nylon bristle brush. Nylon is
x
o
subject to melting.
Protective rubber gloves (optional)
o
Preparing the Oven for Cleaning
1. Place the oven in the
OFF
key repeatedly until the
OVEN OFF
screen is displayed.
2. Open the oven door to expedite cooling
DO NOT clean the oven while blower is operating.
x
o
Daily Cleaning
Step 1: Prepare Oven
When oven is off and has cooled, remove ceramic cooking
platter (Figure 20).
DO NOT remove the circular ceramic waveguide cap
x
o
during cleaning. It should remain in place throughout
the entire cleaning process.
CAUTION:Wait until oven is cool. Ceramics are
breakable, so handle with care.

Maintenance

Oven
®
Oven Guard. The use of
®
mode by pressing the
BACK
/
COOLING DOWN
Step 2: Clean Internal Oven Surfaces
a. Remove cook chamber filter located on the rear-
left bottom corner inside of cook chamber and
clean.
b. Spray TurboChef Oven Cleaner on internal
®
surfaces and inner door of oven. Allow it to sit
five minutes before wiping with a damp cloth.
c. Remove stubborn stains with a non-metallic scrub
brush or pad.
d. Rinse surfaces with clean warm water and cloth
until cleaner is removed.
e. Wipe dry. Make sure to empty and clean grease
tray found behind vent in front of oven (Figure 20).
CAUTION:Do not leave standing water in the
bottom of chamber as recirculating water may
block the air passage.
Step 3: Clean Ceramic Cooking Platter
a. In a well ventilated area, spray ceramic cooking
platter with TurboChef
b. Rinse with warm water and dry.
DO NOT soak the platter in water or place in
x
o
dishwashing machine.
Step 4: Apply Oven Guard
a. Spray a thin layer of TurboChef
all interior surfaces, including the ceramic wave
guide cap.
b. Install the clean ceramic cooking platter into the
oven - raised edge to the front of the chamber.
c. Turn the oven on and allow it to heat up to
temperature.
DO NOT spray Oven Guard on cooking platter.
x
o
CAUTION:Do not leave standing water in the
bottom of chamber as recirculating water may
block the air passage.
Monthly Cleaning - Exhaust Cover
(Figure 20)
On a monthly basis, apply the following steps:
1. Remove the exhaust cover from the back of the oven.
2. Clean the fan guard.
3. Reinstall the exhaust cover.
MAINTENANCE
Oven Cleaner.
®
Oven Guard on
®
17