Tunturi F35 Owner's Manual page 5

CONSOLE
Attach the wires from the handlebar and
1.
handlebar support tube to the corresponding
console outlets. Thread the wires into the
handlebar. Be careful not to damage the wires
when attaching the console.
Slide the meter on the top of the handlebar
2.
support tube and attach it with three locking
screws through the plastic sleeve.
PEDALS
The pedals are distinguished by the markings
1.
(= right) and (= left) on their shafts. Fasten
R L
the right pedal to the right pedal crank turning
clockwise and the left pedal to the left pedal
crank turning counterclockwise.
Fasten the pedal bands first into the retainer
2.
at the device. Thread the band through the
pedal loop and push the band opening into the
projection in the pedal.
Fasten the pedal bands to the pedal outside.
3.
Push the band through the locking buckle and the
O W N E R ' S M A N U A L
band locks automatically.
The length of the band can be adjusted with the
4.
locking buckle.
SEAT
Attach the seat to the seat support: tighten the
locking nuts in opposite directions. Please note
that you can adjust both seat inclination and the
distance of the seat from the handlebar. Once the
distance and inclination are set how you want,
tighten the locking nuts carefully.
F35: POWER CORD
Plug the socket end of the transformer cord into
the connector, just above the rear support in the
centre of the frame, and the other end into the
wall socket. Make sure the power cord does not
run underneath the device. To prevent damage
to the cord, we recommend you tie it to the
protector next to the connector.
The device must be connected to a
NOTE!
GB
• •
F 3 0 F 3 5
5