Table of Contents
Advertisement
If you are routing, edit the Port IP address to set
d
it to
or to a valid IP address for the
UNNUMBERED
WAN link.
See
Appendix A
for more information about
using numbered and unnumbered links.
If you are bridging, leave this field at the default
setting.
If necessary, change any of the other parameters
e
to suit your WAN link. In most cases the defaults
can be used.
Press [CTRL]+[E] to submit this configuration.
f
The WAN port is now configured and provided the
remote unit's WAN port has also been configured,
data will be passed across the link.
Enter
at the command prompt to permanently
SAVE
store this configuration in the unit's memory.
Figure 1-15 Edit WAN Port Screen
Setting Up a WAN Link
1-31
Advertisement
Table of Contents
