Setting The System Break Mode Using A Twinaxial Console; Connecting The Twinaxial Cables And Feature Cables To A Network Or Device - IBM System i Manual

v Contain any combination of alphabetic and numeric characters. Some of the special characters can
be used as well.
Tip: Be sure to write down the new password and keep it in a safe place.
6. In the Work with Software Agreements field, type 5 to display and accept the software agreements
for the licensed programs that you want to accept.
You must accept the software agreements for the Licensed Internal Code and the i5/OS before the
server can be used. If you do not accept these agreements, you must power off the server. If you
decline acceptance of the software agreements for the other licensed programs, follow the instructions
on how to remove these from the server.
7. The i5/OS Main Menu is displayed.
Tip: Informational messages might be displayed on the Display Messages window. Press Enter.
8. Return to Setting up a twinaxial console and continue with the next step.
Related tasks
Setting up a twinaxial console

Setting the system break mode using a twinaxial console

Learn how to set the system break mode using a twinaxial console.
If you are using the ASMI instead of the Hardware Management Console (HMC) to manage hardware,
set the system break mode as described in the following steps:
1. Type chgmsgq qsysopr *break sev(65)
This command puts the system operator's message queue into break mode. Break mode causes any
messages that usually go to the operator's message queue to be displayed immediately.
2. Press Enter.
Any messages that are currently in the queue are displayed. If the Display Messages window is
displayed, press F3 (Exit) to return to the Main Menu.
3. Return to Setting up a twinaxial console and continue with the next step.
Related tasks
Setting up a twinaxial console
Connecting the twinaxial cables and feature cables to a network or
device
Learn how to connect the twinaxial and feature cables.
DANGER
To prevent a possible shock from touching two surfaces with different protective ground (earth),
use one hand, when possible, to connect or disconnect signal cables. (D001)
1. Stop the system or logical partition.
2. Type PWRDWNSYS *IMMED on the command line of the twinaxial console, and then press Enter.
3. Connect the twinaxial cable to the twinaxial connector on the cable as shown in the following figure:
Managing the twinaxial console
11