Operation - DeWalt DWS535B Instruction Manual

Kerf indicators 16 are also located on the inside of the foot
plate to keep the saw square when cutting.
Cut Length Indicator (Fig. H)
The markings on the side of the foot plate show the length
of the slot being cut into the material at the full depth of the
cut. The markings are in increments of 1/8" (3.2 mm).
Fig. H

OPERATION


WARNING: To reduce the risk of injury, turn unit
off and disconnect it from power source before
installing and removing accessories, before
adjusting or when making repairs. An accidental
start-up can cause injury.
iMPORTAnT: Always make sure the depth adjustment
locking lever is in the down position before operating saw.
Trigger Switch (Fig. A)

WARNING: To reduce the risk of serious personal
injury, hold saw with both hands when starting
the saw to avoid kickback.
Press the trigger switch 1 to turn the tool on. Release the
trigger switch to turn the tool off.
nOTE: This tool has no provision to lock the trigger in
the on position and should never be locked on by any
other means.
Changing Blades (Fig. A, I–L)
iMPORTAnT: Most replacement blades come with a round
arbor center opening which must be knocked out so a
diamond-shaped arbor center is exposed. Only blades with
a diamond-shaped arbor center can be used on this saw.
NOTICE: Never install a blade without removing the knockout.
Lack of blade engagement will cause the blade to come into
contact with other parts of the saw causing tool damage.
To Remove Knockout

WARNING: ALWAYS use eye protection. All
users and bystanders must wear eye protection that
conforms to ANSI Z87.1.

WARNING: Make sure that bevel adjusting locking
lever is tight and secure after using it to remove
knockout. If blade adjustment shifts while cutting it
may cause binding and kickback.
Fig. I
17
Place the round center hole of the blade into the notch
on the top of the bevel adjustment lever
saw and blade firmly, pull until the knockout pops out. The
diamond-shaped arbor center is now exposed.
To Install the Blade (Fig. A, J, K)
1. Loosen and remove the blade clamping screw
with the wrench provided, by turning it clockwise as
indicated by the arrow on the outer clamp washer
2. Remove outer clamp washer
3. Using the lower blade guard retracting lever
the lower blade guard 5
iMPORTAnT: When retracting the lower blade guard
to install the blade, check the condition and operation
of the lower blade guard to assure that it is working
properly. Make sure it moves freely and does not touch
the blade, foot plate or any other part, in all angles and
depths of cut.
4. Place blade 21 on saw spindle
clamp washer 23 , making sure that the blade will
rotate in the proper direction (the direction of the
rotation arrow on the saw blade and the teeth must
point in the same direction as the direction of rotation
arrow on the lower blade guard).
iMPORTAnT: Always ensure the diamond-shaped arbor
center of the blade aligns with the raised diamond-
shaped arbor center on the outer clamp washer.
Fig. K
21
20
nOTE: Do not assume that the printing on the saw blade
will always be facing you when properly installed.
5. Place outer clamp washer
the large flat surface against the blade and the wording
on the outer clamp washer facing you as shown in
Figure K.
English
17
17
8 . Grasping the
18
20
.
20
, retract
3
.
22 against the inner
22
on saw spindle with
20 22
.
7