Operation; Installing And Removing The Battery Pack - DeWalt DCS354 Instruction Manual

3. Secure the guide in place by turning the depth/cut
adjustment knob 19
turn the depth/cut adjustment knob counterclockwise.
Fig. G
7
Cut Guide (Fig. H)
Optional Accessory
This feature allows you to more accurately track a marked
cut line.
1. Insert the guide arm
right sides of the cut guide block
2. Adjust the length of the guide by pulling out or pushing
inward to achieve the desired length.
3. Secure the guide in place by turning the depth/cut
adjustment knob 19
turn the depth/cut adjustment knob counterclockwise.
nOTE: The guide arm can also be placed in the guard
assembly vertically in order to set the height of a cut.
Fig. H
7
6

OPERATION


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury..

Installing and Removing the Battery Pack

(Fig. I)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
battery pack with the rails inside the tool's handle and slide
clockwise. To release the guide,
7 into the slots on the left and
6 .
clockwise. To release the guide,
8 into the tool handle, align the
it into the handle until the battery pack is firmly seated in
the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the release
button 9 and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual
Fig. I
6
19
Proper Hand Position (Fig. J)

WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main handle
11
Fig. J
.
19
Mode Selector (Fig. A)
DCS356
Your tool is equipped with a mode selector
allows you to select one of the three modes. Select the
mode based on the application and control the speed of the
tool using the variable speed trigger switch
Lock On/Off Button (Fig. A)
Engage the lock on/off button
or right. When the trigger
button fully to either side until it snaps into place will lock
the trigger and disable it from being depressed. Placing
the button in the center position allows the trigger to
operate normally.
English
9
8
10 which
1 .
4 by pushing it to the left
1 is not depressed, pushing the
11
11