D-Link DWL-3200A Command Line Interface Reference Manual page 15

set roguebandselectstatus
set roguebandselect
set radiusname Set RADIUS Server name or IP address
set radiusport Set RADIUS port number
set radiussecret Set RADIUS shared secret
set accountingstate Enable or Disable Accounting server function
set accountingname Set Accounting server name or IP addresss
set accountingport Set Accounting port number
set rate Set Data Rate
set rtsthreshold Set RTS/CTS Threshold in bytes
set shortpreamble Set Short Preamble
set sntpserver Set SNTP/NTP Server IP Address
set ssid Set Service Set ID
set ssidsuppress Set SSID Suppress Mode enable or disable
set SuperG Enable or Disable Super G Features
set systemname Specify Access Point System Name
set sta2sta Set wireless STAs to wireless STAs connect state (WLAN Partition)
set eth2sta Set ethernet to wireless STAs connect state
set telnet Set Telnet Access Mode to enabled or disabled
set timeout Set Telnet Timeout in seconds, 0 is never, 900s Max
set tzone Set Time Zone Setting
set daylightsaving Set Day Light Saving Time
set wlanstate Select the operational state of wlan: enabled or disabled
set wirelessmode Used to select the wireless mode of operation for the AP: 11b, 11g, 108g set wirelessmode [11b:11g:108g]
set wmm Enable or Disable WMM Features
802.11 a/g Dual Band Access Point Command Line Interface Manual
13
set roguebandselectstatus [disable:enable]
set roguebandselect
Note: After enter this command, the CLI will list the security type for
selection
set radiusname <DNS name::xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set radiusport <xxxxx>
Explanation: <xxxxx> is port number, default value is 1812
set radiussecret
set accountingstate [disable:enable]
set accountingname <DNS name::xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set accountingport < xxxxx>
Explanation: < xxxxx> is port number, default value is 1813
set rate [best:1:2:5.5:6:9:11:12:18:24:36:48:54]
set rtsthreshold <xxxx>
set shortpreamble [0:1]
Explanation: 0=disable:1=enable
set sntpserver <xxx.xxx.xxx.xxx>
Explanation: <xxx.xxx.xxx.xxx> is IP address
set ssid <SSID>
set ssidsuppress [0:1]
Explanation: 0=disable:1=enable
set SuperG [0:1]
Explanation: 0=disable:1=enable
set systemname <name>
set sta2sta [0:1]
Explanation: 0=disable:1=enable
set eth2sta [0:1]
Explanation: 0=disable:1=enable
set telnet [0:1]
Explanation: 0=disable:1=enable
set timeout [0-900]
set tzone [0=GMT]
Note: use get tzonelist to get tzone information
set daylightsaving [0:1]
Explanation: 0=disable:1=enable
set wlanstate <0:1>[0:1]
Explanation: 0=disable:1=enable
set wmm [disable:enable]