Note:
v Use \ to represent the comma in the volume name or session id.
For example, cnLun\10\usLun.
v When SRA is set to Pre-Configured and the TPC-R option is enabled, check the
remote copy session IDs and volume names on the DS8000 storage before you
set up the Name Filter. It is suggested that you leave the Name Filter empty in
the TPC-R scenario.
v Prefixes for session IDs are the same on both the protected (primary) and the
recovery (secondary) site. Session ID x can be set up as 0x if x is only one
character.
For Example: Session ID 9 can be set up as 09; Session ID E can be set up as 0E.
v Prefixes for the volume name can be different for each site, but the prefixes must
be paired on both sites.
For Example: The protected site volume name is pro_volumeA and on the
recovery site it is mapped to rec_volumeB. Then, in the Name Filter of the
protected site, enter prefix pro. On the recovery site, enter rec.
Configure the Name Filter parameter when you are adding an array manager to
the VMware Site Recovery Manager. See Figure 39 on page 50.
49
Chapter 5. Usage