GMC Buick Encore GX 2020 Owner's Manual page 258

: Press to turn the cruise control
system on and off. A white indicator
comes on in the instrument cluster
when cruise is turned on.
: Press to disengage cruise
control without erasing the set
speed from memory.
+RES : If there is a set speed in
memory, press up briefly to resume
that speed or press and hold to
accelerate. If cruise control is
already active, use to increase
vehicle speed.
SET : Press down briefly to set the
speed and activate cruise control.
If cruise control is already active,
use to decrease vehicle speed.
Setting Cruise Control
If is on when not in use, SET or
+RES could get bumped and go into
cruise when not desired. Keep
when cruise is not being used.
To set a speed:
1. Press to turn the cruise
system on.
2. Get to the speed desired.
3. Press down and release
SET . The desired set speed
briefly appears in the
instrument cluster.
4. Remove your foot from the
accelerator pedal.
The cruise control indicator on the
instrument cluster turns green after
cruise control has been set to the
desired speed. See Instrument
Cluster 0 107.
Driving and Operating
Resuming a Set Speed
If the cruise control is set at a
desired speed and then the brakes
are applied or
cruise control is disengaged without
erasing the set speed from memory.
Once the vehicle speed reaches
about 40 km/h (25 mph) or more,
off
press +RES up briefly. The vehicle
returns to the previous set speed.
Increasing Speed While Using
Cruise Control
If the cruise control system is
already activated:
Press and hold +RES up until
the vehicle accelerates to the
desired speed, then release it.
To increase the speed in small
increments, press +RES up
briefly. For each press, the
vehicle goes about 1 km/h
(1 mph) faster.
The speedometer reading can be
displayed in either English or metric
units. See Instrument Cluster 0 107.
The increment value used depends
on the units displayed.
257
is pressed, the