GMC Buick Encore GX 2020 Owner's Manual page 185

184 Infotainment System
task. If a selection is made using a
manual control, the voice
recognition dialog will progress in
the same way as if the selection
were made using a voice command.
Once the system completes the
task, or the session is terminated,
the voice recognition dialog stops.
An example of this type of manual
intervention is touching an entry of a
displayed number list instead of
speaking the number associated
with the entry desired.
Canceling Voice Recognition
Touch or say Cancel or Exit
to terminate the voice
recognition session and show
the display where voice
recognition was initiated.
Press on the steering wheel
controls to terminate the voice
recognition session and show
the display where voice
recognition was initiated.
Natural Language Commands
Most languages do not support
natural language commands in
sentence form. For those
languages, use direct commands
like the examples shown on the
display.
Helpful Hints for Speaking
Commands
Voice recognition can understand
commands that are naturally stated
in sentence form or direct
commands that state the application
and the task.
For best results:
Listen for the prompt before
saying a command or reply.
Speak the command naturally,
not too fast, not too slow.
Use direct commands without a
lot of extra words. For example,
Call <name> at work, Play
followed by the artist or song
name, or Tune followed by the
radio station number.
Navigation destinations can be
made in a single command
using keywords. A few examples
are: I want directions to an
address, I need to find a place
of interest or (POI), or Find
contact.
The system responds by
requesting more details. For
other POIs, say the name of a
category like Restaurants,
Shopping Malls, or Hospitals.
Navigating to a destination
outside of the current country
takes more than one command.
The first command is to tell the
system where the navigation will
take place, such as an Address,
Intersection, POI, or Contact.
If Address or Intersection is
selected, the second command
is to say, Change Country.
Once the system responds, say
the country before saying the
rest of the address and/or
intersection.
If POI is asked for, say Change
Location, then Change
Country.