Replacement procedure
1. Remove the computer cover. See "Computer cover" on page 61.
2. Remove the front bezel. See "Front bezel" on page 62.
3. Remove the drive bay assembly. See "Drive bay assembly" on page 65.
4. Remove a memory module.
5. Install a memory module.
Note: During the installation, ensure that you align the memory module to the slot and press down on
both ends until the latches are fully engaged with a click.
6. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.
PCI-Express connector cable
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
.
Chapter 6
Hardware removal and installation
83