Heat Sink (For The M.2 Solid-State Drive) - Lenovo ThinkCentre M70s Hardware Maintenance Manual

8. Install the 2.5-inch secondary storage drive.
9. Install the 2.5-inch secondary storage drive with the bracket.
10. On the bottom of the drive bay assembly, connect the signal cable and the power cable to the new
storage drive.
11. Reinstall all the removed parts. Then, reconnect the power cord and all disconnected cables to the
computer.

Heat sink (for the M.2 solid-state drive)

Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Replacement procedure
1. Remove the computer cover. See "Computer cover" on page 61.
2. Remove the front bezel. See "Front bezel" on page 62.
3. Remove the drive bay assembly. See "Drive bay assembly" on page 65.
4. Refer to one of the following heat sink types to replace it.
• Type 1 and Type 2
.
Chapter 6 Hardware removal and installation
71