Place; Desktop Placement; Wall-Mounting - Harman JBL BAR 9.1 Owner's Manual

1)
• Switch on or to standby
2)
• Select the TV source (default, for audio input from TV
connection where the
prioritized over the
3) (Bluetooth)
• Select the Bluetooth source
• Press and hold to connect another Bluetooth device
4)
• Select the level of Dolby Atmos/DTS:X effect: middle
(default), high or low
5) HDMI
• Select the source
• Press and hold for more than 5 seconds to enter the
calibration mode for wireless surround sound
6) + / -
• Increase or decrease the volume
Press and hold to increase or decrease the volume
•
continuously.
7) (Mute)
• Mute/unmute
8)
• Select the bass level for subwoofer: 1/2/3 (default)/4/5
9)
• Select the surround sound level for rear speakers: middle
(default), high or low
connector is
connector)

4. PLACE

4.1 Desktop placement

Place the soundbar, detachable speakers and subwoofer on a
flat and stable surface. Refer to the recommended distance in
the following diagram.
>10cm/4"
1m/3ft
1-1.4m/
3-4.6ft
NOTES:
− The power cord shall be properly connected to power.
−
Do not place any objects on the top of the soundbar, detachable
speakers or subwoofer.
−
Charge the detachable speakers in time to ensure sufficient battery
power (See " Connect the detachable rear speakers" in the chapter
"SETUP").

4.2 Wall-mounting

Wall-mount the soundbar and detachable rear speakers together
or separately.
3m/10ft
5cm/2"
2.5-3.0m/8.2-9.8ft
1-1.4m/
3-4.6ft
www.jbl.com
7 7