Re-Connect The Subwoofer - Harman JBL BAR 9.1 Owner's Manual

3. To enter the software update mode, press and hold
the soundbar for more than 10 seconds.
→ "
" is displayed.
→ " ": Software updating underway
→ " ": Software updating completed
→ The soundbar returns to the last selected source.
NOTES:
− Keep the soundbar powered on and the USB storage device mounted
before software updating is complete.
− "
speakers are not properly mounted onto the soundbar.
− " " is displayed if no USB storage device is detected,
and 5 minutes later, the soundbar exits the software update mode.
− "Error"is displayed if software updating has failed twice.
and - on
" is displayed if the two detachable

11. RE-CONNECT THE SUBWOOFER

The soundbar and subwoofer are paired at factories. After
power-on, they are paired and connected automatically. In some
special cases, you may need to pair them again.
2
4
To re-enter the subwoofer pairing mode
1. On the rear panel of subwoofer, press and hold
fast flashing white.
2. To enter the subwoofer pairing mode on the soundbar, press
and hold on the remote control for more than five seconds.
Press - on the remote control.
→ " ": The subwoofer is ready for pairing.
→ " ": The subwoofer is connected.
NOTES:
−
The subwoofer will exit the pairing mode in three minutes if pairing and
connection are not completed.
slow flashing white.
POWER
1
POWER
3
until it turns
turns from fast flashing white to
www.jbl.com
21 21