Harman JBL BAR 9.1 Owner's Manual page 15

2) Calibrate the speaker position
1. Place the detachable rear speakers in your desired location.
2. On the remote control, press and hold
" " is displayed on the soundbar.
→ Countdown starts from 5 to 1.
→ Calibration tone is heard. Audio calibration starts.
→ "
": Calibration ongoing.
→ "
": Calibration of the speaker position is
completed successfully.
3. To select suitable surround sound, press
switch between high, low or middle (default).
NOTES:
−
During calibration, all buttons on the remote control are disabled
except for and .
−
" " is displayed if calibration failed.
2-CALIBRATION
2 DONE
>5S
L
R
R
until
repeatedly to
6.3.2 Dolby Atmos / DTS:X
®
With Dolby Atmos or DTS:X, overhead audio distribution is
provided for powerful 3D sound immersion.
1. To play the surround sound of DOLBY ATMOS or DTS:X,
connect and play your Blu-ray player or streaming device
as described under "Connection with your TV and digital
devices" in the "CONNECT" chapter.
2. To select suitable strength for Dolby Atmos or DTS:X, press
on remote control to switch between middle (default),
high, low or off.
LOW
®
HIGH
MID
MID
HIGH LOW
www.jbl.com
15 15