Table of Contents
Advertisement
instructions below.
~
9901756
~1382180
ACCESSORIES
- - - - - 1097050
* --------
1097200
*
NOTE:
See #1 thru #3 below with
Standard Connector Base use
Screw
9900142;
with Hubbell
Base use Screw
9900144.
*
No sold
separatelY~
1097051
*
1097900 -
---&l!i'!t
Slide Oiler
*
1097800
Complete
*
No sold separately-----+-Jl.l.ll.
Part No.
Description
Quantity used
Part No.
if more than 1
1097050
1097051
1097200
1097600
1097700
1097800
1097900
1. Disconnect electrical power.
2. Remove connector base and place bracket under
neath. To do this the wiring will have to be disconnected
from the connector and wires run through the bracket.
3. Rewire electrical connector and screw down on bracket
with screws provided.
Slide Oiler Assy. (Parts marked with
*)
Slide Oiler Complete (W/Bracket
&
Tube)
Stem Sub. Assy. Complete
Body Washer
Body Glass
Tube Glass
Sight Feed Gasket
INSTALLATION OFTHE SLIDE OILER
Not sold Separately
*
Not sold Separately
*
Not sold Separately
*
/
1097600
*
-----
~
1098300
1382180
1382181
9900142
9900144
9900338
9901756
4. Remove bottom portion from oiler and place oiler in the
bracket. Screw on large nut to hold in place.
5. Slide nut and little sleeve on to oiler tube. Connect this
bottom portion of oiler removed in Step #4.
6. Connect tube and bottom portion to oiler body.
7. Fasten tube down underneath drip pan with screw provided.
,
1382181
9900338
Description
Quantity used
more than 1
Connector
Oiler Bracket
Oiler Tube
3/8" Lg. Screw (Standard Connector)
3
1/2" Lg. Screw (Hubbell Connector)
3
6-32
x 5/16 Flat Head Screw
1/2-20 Elastic Half Nut
SUllE OILER
NOTE:
See installation
Millimeter Equivalents
Machine Strokes: 1-1/8" Ex. Short - 29mm; 1-1/4" Short - 32mm;1-3/8" Med. - 35mm; 1-1/2" Long - 38mm; 1-2/4" Ex. Long - 44mm;
Machine Sizes: 5" -127mm; 6" -152mm;
7"
-178"mm; 8" - 203mm; 10" - 254mm; 14" - 356MM.
35
Advertisement
Table of Contents
