Wolf NEW PACER 100 Series Parts And Service Manual page 16

MAINTENANCE BELT SHARPENER CONTINUED
4
HOW TO DISASSEMBLE SERIES XI SHARPENER
9
3 3
1. Remove top belt.
2. Remove three screws from nylon guide.
3. Remove four Backplate screws.
4. Remove two screws and cap of
2
Front Housing.
7
5. Remove two screws and Cover Plate.
6. Remove Follower screw, Spring and
Follower. Loosen Clamp screw. See
Follower information on page 7 (at the
bottom).
7. Remove the two Pins from Arm
Release Rod.
8. Remove nut from bottom of Release
10
3
3
Rod. Rod can then be removed.
9. Remove Locknut, Worm wheel and
Key at top of Sharpener.
10. By sliding shaft down, the complete
7
Reversing Drive Assembly can then
be removed complete with
8
Sharpening Head.
(NOTE: On new models disregard #'s 7 & 8.
A---<::: ­
ADJUSTMENT OF PRESSERFOOT
LOCK ASSEMBLY
NOTE:
The Presserfoot Lock Assembly needs to
be adjusted only if the Presserfoot Rod is not
holding.
The Presserfoot mechanism is positioned
on the Front Housing and is disassembled by
removing 2 screws (A at left). To reassemble,
release the spring tension by depressing the
Locking Lever with a screw driver as shown
on page 11. Follow the instructions from
paragraph 3 also on page 11.
14