Mounting - Tripp Lite PowerVerter 93-2642 Owner's Manual

Mounting

WARNING! Mount your Inverter/Charger BEFORE DC battery and AC power
connection. Failure to follow these instructions may lead to personal injury
and/or damage to the Inverter/Charger and connected systems.
Tripp Lite manufactures a variety of different Inverter/Chargers with a variety of different mounting options for use in vehicular or non-vehicular
applications. Tripp Lite recommends permanent mounting of your Inverter/Charger in any of the configurations illustrated below. User must
supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the
Inverter/Charger. Contact Tripp Lite if you require further assistance in mounting your Inverter/Charger.
Note: When operating an MRV2012UL marine model in a marine application, refer to the accompanying marine
owners' manual addendum.
Whether mounted horizontally or vertically, the Inverter must be located in an enclosed compartment, shielded
from outside weather conditions.
Using the measurements from the diagram, install two user-supplied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving the
A
heads slightly raised. Slide the Inverter/Charger forward over the fasteners to engage the mounting feet molded on the front of the
B
Inverter/Charger cabinet. Install and tighten additional user-supplied ¼" (6 mm) fasteners into the mounting feet molded on the rear and
sides of the Inverter/Charger cabinet*. The rear feet extend beyond the unit's cabinet to provide for adequate ventilation space behind the
cooling fan(s); they should not be removed.
The polycarbonate cabinet and mounting feet of your Inverter/Charger are durable enough to allow for vertical mounting as well, if your
vehicle compartment requires this configuration. For vertical mounting, the control panel of the Inverter/Charger should face up.
Allow 2" minimum front and rear clearance for adequate ventilation.
Note: Cabinets may have different front panel features, but all mount as per the figure above.
* Model includes front, rear and side mounting feet.
9.59 in.
(24.35 cm.)
5.57 in.
(14.16 cm.)
A
5.57 in.
(14.16 cm.)
9.59 in.
(24.35 cm.)
B
5.87 in.
(14.91 cm.)
5.87 in.
(14.91 cm.)
1.64 in.
(4.15 cm.)
9R