Mounting - Tripp Lite PINV750 Owner's Manual

Mounting

WARNING!
Mount your Inverter BEFORE DC battery connection. Failure
to follow these instructions may lead to personal injury and/
or damage to the Inverter and connected systems. Ensure the
inverter never is mounted in a vertical position (fan or outlet side
facing up or down). Mounting an inverter in a vertical position
allows debris to enter the unit and inhibit proper operation of its
cooling system, which can void the inverter's warranty.
Tripp Lite recommends permanently mounting the Inverter in the
configurations illustrated below. The Inverter features integral
mounting brackets on the front and rear of the unit. The user must
supply mounting hardware and is responsible for determining whether
hardware and mounting surfaces adequately support the weight of the
unit.
Flat Surface
Mount
Use the measurements as shown in the following diagrams to install
two user-supplied fasteners at the DC side of the unit, leaving the
heads slightly raised. Slide the unit over the fasteners to engage
the mounting bracket slots. Tighten fasteners. Install two additional
fasteners over the remaining mounting brackets in the front for proper
securement.
18-06-149-93385F.indb 10
Wall Mount
10
7/16/2018 3:50:24 PM