Condensing Units; Equipped With Econet; Dual 7-Segment Led; Line Voltage Connector - Rheem RA17 Series Installation Instructions Manual

Condensing Units

Condensing Units Equipped
with the EcoNet™ Enabled
2-Stage Control System
EcoNet™ enabled is the next generation of the
Integrated Compressor Control (ICC) and is an
integral part of the EcoNet™ Communication
System with the following features:
Control Description

Dual 7-Segment LED

• Displays status and diagnostic codes see
Status and Diagnostic Description
• Displays diagnostic fault recall see Test
Fault Recall)
Memory
Card
Up Button
Select Button
Dual 7 Segment
LED
Thermostat
Connection
(see Figure 1)
ode
Figure 1. EcoNet Communication System™ Board
Figure 6
INSTALLATION
CAUTION:
SUDDENLY AND WITHOUT WARNING. Solid red
light indicates a thermostat call for unit operation is
present at the ICC control. ICC control will attempt
to start unit after short cycle timer expires or when
in Active Protection mode will attempt to restart
unit prior to Lockout mode.

Line Voltage Connector

• ine voltage is connected to control board at
terminals 240VAC
Thermostat Connector (P9)
• R – 24VAC from the indoor unit 24VAC
transformer (40 VA minimum)
UNIT MAY START
Ambient
Sensor
O.D. Fan
2 Stage
Compressor
Solenoid Output
High Pressure
Control Input
Low Pressure
Control Input
Compressor
Contactor "CC"
Low Voltage Fuse
Line Voltage
Connection
21