External Battery Pack Connection - Tripp Lite 1400VA Owner's Manual

Connection (optional)
Your UPS will function properly without these connections.
Serial Port Connection
Using the serial cable provided, connect a serial port from a
computer to a serial port on your UPS. Install on the computer
the Tripp Lite power protection software appropriate to its
operating system. If your UPS features two serial ports, a
second serial computer may be connected.
USB Port Connection
Using the USB cable provided, connect a USB port from a
computer to a USB port on your UPS. Install on the comput-
er the Tripp Lite power protection software appropriate to
its operating system. If your UPS features two USB ports,
a second USB computer may be connected.
EPO Port Connection
Using the RJ-11 cable provided, connect the Emergency
Power Off (EPO) port of your UPS to a user-supplied normally
closed or normally open switch according to the circuit diagram
at the right. The EPO port is not a phone line surge
suppressor; do not connect a phone line to this port.

External Battery Pack Connection

Since your UPS has internal batteries, external batteries are
only needed to extend runtime. Adding external batteries
will increase recharge time as well as runtime.
The diagram to the right shows the location of your UPS's
External Battery Connector, where you will insert the cable that
is attached to your battery pack. Complete installation and
mounting instructions for your battery pack appear in the
battery pack's owner's manual. Make sure that cables are fully
inserted into their connectors. Small sparks may result during
battery connection; this is normal.
Serial Connection: SMART3000RM2U shown
USB Connection: SMART3000RM2U shown
EPO Connection: SMART3000RM2U shown
EPO Circuit Diagram
External Battery Connection:
SMART3000RM2U shown
7