Storage And Service - Tripp Lite 1400VA Owner's Manual

Basic Operation
Ground Screw: Use this to connect any equipment that requires a chassis ground.
External Battery Connector (Select Models Only): Use to connect Tripp Lite
external battery packs for additional runtime. The specifications section of this
manual lists the Tripp Lite external battery packs that are compatible with your
model. Refer to instructions available with the battery pack for complete con-
nection information and safety warnings.
Input Breaker: Prevents high input current from damaging the UPS or the
attached load. If this breaker trips, make sure your UPS is connected to nominal
120V AC power before resetting the circuit breaker by pushing the breaker
switch in to reset.
Output Breaker(s) (Select Models Only): Your UPS may feature one or more
breakers that protect your UPS from output overload. If one or more breakers
trip, remove some of the load on the circuit(s) and allow the UPS to cool before
resetting the circuit(s) by pressing the breaker switch(es).

Storage and Service

Storage
Before storing your UPS, place it in the OFF mode by putting it in STANDBY, then unplugging it (See
Basic Operation). If you store your UPS for an extended period of time, recharge the UPS batteries
once every three months by following Step 1 in the Connection section and allowing the UPS to
charge for 4-6 hours before placing it back in storage. If you leave your UPS batteries discharged
for an extended period of time, they will suffer a permanent loss of capacity.
Service
If returning your UPS for service, contact your local Tripp Lite dealer or distributor. They will refer
you to a service center. Please carefully pack the UPS using the ORIGINAL PACKING MATERIAL
that came with the unit. Enclose a letter describing the symptoms of the problem. If the UPS is within
the 2 year warranty period, enclose a copy of your sales receipt.
continued
11