About Your Hardware; Hardware Specifications - Watchguard AP225W Hardware Manual

WatchGuard AP225W Hardware Guide

About Your Hardware

Hardware Specifications

Hardware Description
Chipset Qualcomm QCA4019 SOC
Processor Qualcomm IPQ4019 717MHz quad core ARM processor with 512 MB RAM and 32 MB
and RAM Flash
Radio Type
n
and
n
Frequency
n
Band
Antennas Six integrated omnidirectional antennas
Ethernet
n
Interfaces
n
n
n
Power PoE In LAN/Uplink port (PoE+ 802.3at, PoE 802.3af), 48V
Interface
DC In: 12V DC 2A
Power Maximum: 12W
Consumption
MTBF 440,000+ hours at 40°C
(Mean Time
Between
Failures)
Dimensions 186 mm X 124 mm X 25.4 mm (7.3" x 4.9" x 1")
Weight 0.450 kg (1 lb)
2
2.4 GHz, 802.11b/g/n. Max data rate: 400 Mbps
5 GHz, 802.11a/n/ac. Max data rate: 867 Mbps
Third radio for multi-purpose security and wireless network scanning
1 x 10/100/1000 Mbps Gigabit Ethernet (PoE In LAN/Uplink) for wired LAN
connection through a switch or hub. This port also provides PoE (802.3af/at) power
for the device. The AP225W requires PoE+ (802.3at) for full functionality and
capabilities to enable power on the LAN3/PoE Out port.
2 x 10/100/1000 Mbps Gigabit Ethernet (LAN1, LAN2) for wired extension of an
SSID or a VLAN extension. Link aggregation is not supported.
1 x 10/100/1000 Mbps Gigabit Ethernet (LAN3 / PoE Out) for wired extension of an
SSID or a VLAN extension, and also provides PoE (802.3af) power to other
devices. The AP must be connected to PoE+ (802.3at) or DC power to enable
power on the LAN3/PoE Out port. Link aggregation is not supported.
2 x pass-through ports for extension of the wired network.
WatchGuard Technologies, Inc.