Sewing; Points To Note Before Sewing; Adjusting The Presser Foot Floating Amount (Minute Lifting Amount) - Brother S-7220D Instruction Manual

4

Sewing

Points to note before
sewing
CAUTION
• Attach all safety devices before using
the sewing machine. If the machine is
used without these devices attached,
injury may result.
• Turn off
threading and replacing the bobbin, and
when not using or going away from the
sewing machine. The machine may
operate if the treadle is depressed by
mistake, which could result in injury.
• Do not touch any of the moving parts or
press any objects against the sewing
machine while sewing. Otherwise, it may
result in injury or damage to the sewing
machine.
• Secure the table so that it will not move
when tilting back the machine head. If
the table moves, it may crush your feet
or cause other injuries.
• Use both hands to hold the machine
head when tilting it back or returning it to
its original position. If only one hand is
used, the weight of the machine head
may cause your hand to slip, and your
hand may get caught.
Adjusting the presser foot floating
amount (minute lifting amount)
When sewing stretch materials and materials with long
pile, you can make minute adjustments to the floating
amount for the presser foot (1) in accordance with the
material.
1
Turn the sewing machine pulley by hand to move
the feed dog (2) below the needle plate (3).
the power switch while
2
Use the lifting lever to lower the presser foot (1).
3
Loosen the nut (4).
Raise Lower
Levantar Bajar
4
Use a screwdriver to turn the adjustment screw
(5) to adjust the floating amount.
• To raise the presser foot (1), turn the
adjustment screw (5) clockwise.
• To lower the presser foot (1), turn the
adjustment screw (5) counterclockwise.
5
Tighten the nut (4).
After making the adjustment, sew a piece of material to
check the floating amount.
46