Troubleshooting - Topcom Twintalker 9500 Airsoft Edition Manual

TT 9500 Airsoft Edition.book Page 10 Monday, January 14, 2013 4:28 PM
10
Dual Channel Monitor (DCM) allows you to monitor a second channel
with CTCSS/DCS code.
• Press the
DCM OFF" will flash on the display.
• Press the
button
10
• Press the
channel selection and go to CTCSS
selection. (Press the
again to go to DCS selection)
• Press the
button
10
DCS code.
• Press the
PTT
and return to stand-by mode.
• To disable the function select "OFF" when
selecting the DCM channel.
When the Dual Channel Monitor function is activated, the PMR will switch
sequentially between the standby channel + CTCSS/DCS code and the
Dual Channel + CTCSS/DCS code.
13.15 Button Lock
• Press and hold the
three seconds to activate the Button lock
mode. The button lock icon is displayed on
the LCD Screen.
• Press and hold the
for three seconds deactivate button lock
The -button , the
12
PTT
1
button will still be functional when the Button Lock
is activated.
-button 7 twelve times,"
-button or the -
11
to change the channel.
-button 7 to confirm the
7
-button
-button or the -
11
to change the CTCSS code or
-button to confirm
12
-button 7 for
-button 7 again
-button 6 and the -
Twintalker 9500 (RC-6406) Airsoft Edition
13.16 Display back light
To activate the backlight of the LCD display, press any button except the
- button or the button 6 .
12
PTT
The LCD backlight will light up for 6 seconds.
14 Earpiece connection
The connector is located on the upper side of the unit
Insert the earpiece plug into the connector (2,5mm jack).
The small button on the earpiece has the same function as the
button on the unit
12
When you use the - button from the Earpiece, you must also
12
PTT
use the microphone from the earpiece to talk into
Do not connect other earpieces. This may damage your
device.

15 Troubleshooting

No power Clean the battery contacts with a soft cloth.
Replace the batteries.
No transmission Make sure the
PTT
completely before you speak.
Monitor the channel activity and switch to another
channel if the current is used.
No reception Check the speaker volume.
Make sure that you are in the reception range of
the sender and change if necessary your
location.
Limited Range and The talking range depends on the terrain.
noice during Steal constructions, concrete buildings or the use
transmission in vehicles have a bad influence on the range.
Try to avoid as many obstacles as possible and
communicate in a clear line of sight.
Change your locations.
2 .
-
PTT
.
- button is pressed
12