Table of Contents
Advertisement
MAINTENANCE
If your valve requires maintenance or replacement, follow these instructions:
NOTE: Always shut off the gas and
disconnect the power supply before
removing the valve.
1) Open the front door and carefully remove
the logs and lava rock.
2) Remove the burner by removing the two
1/4" hex head screws. See diagram below.
3) Open the front pedestal door and unhook
chain. You may want to put a soft cloth on
the base of the unit so that when the pedestal
door is open it doesn't scratch the paint. See
diagram below.
Regency FG38 FireGenie Freestanding Gas Stove
REMOVING VALVE
4) Remove the two outside frame pieces by
removing two screws per side. See diagram
below.
5) Open the side pedestal door by unscrewing
the 2 Philips screws.
6) Disconnect the valve wires from the 9 pin
connector, located on the right side of the
connector.
Valve wires consist of 2 orange, 1 yellow and
2 purple colored wires.
9 Pin Connector
7) At this point you should disconnect the gas
at the valve.
8) Remove the pedestal back cover by removing
the 4 Philips screws.
9) Disconnect the ground wires.
Ground
Wires
10) Remove the eight 1/4" hex head screws
holding the burner tray assembly in place.
11) Carefully lift the burner tray assembly out.
12) To replace the burner tray assembly, simply
reverse these instructions.
19
Advertisement
Table of Contents
