Laney CUB-SUPER Series User Manual page 6

CUB-RANGE
CUB-SUPER12 FEATURES
12
9 - BOOST - Determines the amount of pre boost hitting the first tube in the amplifiers signal path.
Dialling in more BOOST will have the effect of pushing a clean amp into warm tube clipping or
naturally compressing an already clipping amplifier.
10 - BOOST LED - Indicates that the BOOST is engaged.
11 - INPUT SOCKET
of the amplifier - producing 15 watts RMS of tube tone. Plugging into the <1Watt input switches the
output power stage down to <1 watt RMS. Ideal for recording or bedroom playing.
12 - EXTERNAL SPEAKER
speaker. Should you want to run an external speaker cabinet it can be connected here. Please use a
good quality SPEAKER cable. Connecting an external speaker cabinet will disconnect the internal
speaker. Please make sure you use the correct impedance of speaker cabinet from 8 - 16 Ohms.
13 - FX LOOP SEND
guitar cable. This socket can also be used as a line out.
14 - FX LOOP RETURN - This is where you plug the OUT of your Effect(s). Use a high quality shielded
guitar cable.
15 - FOOTSWITCH SOCKET - This is where you plug in the footswitch. FS2-Mini optional extra. Enables
remote switching of the boost circuit and reverb. Ensure the boost switch (7) is switched in and the
reverb level is set above zero.
16 - POWER SOCKET - Plug in the supplied IEC power cord here.
6
- 15W & <1W inputs. Plugging into the 15W input socket accesses the full power
- Your CUB-SUPER12 is loaded with a HH Custom designed 8 Ohm Internal
- This is where you plug the INPUT of your Effect(s). Use a high quality shielded
13 14 15
USER MANUAL
16
www.laney.co.uk