Laney CUB-SUPER Series User Manual page 3

CUB-RANGE
CUB-SUPER10 FEATURES
1 2
POWER SWITCH & LAMP
1 -
VOLUME - Controls the overall listening volume of the amplifier and is used in conjunction with the
2 -
Gain control (6).
3 - TREBLE - Controls the amps high end response. Start at 4 or 5 and adjust depending on how dark or
bright you want the amplifier to sound.
4 - MIDDLE - Controls the amps midrange response. Start at 4 or 5, lower settings will scoop the mids,
higher levels will allow you to actually hear the guitar in the mix.
5 - BASS - Controls the bass or bottom end of the amplifier's response. As the amp gets louder you may
want to back this off a bit. Start at 7-10 for bedroom volumes.
6 - GAIN - Controls the level of gain/distortion present in the guitar signal. Used in conjunction with the
volume control (2). For clean guitar sounds with plenty of headroom set the gain control low whilst
setting the volume control to the required level. As you dial more gain into the signal it might be
necessary to reduce the volume level accordingly.
7 - BOOST SWITCH - Engages the onboard pre-boost. This is just like kicking in your favourite boost pedal
in front of the amplifier.
8 - BOOST KNOB - Dials in the amount of pre boost hitting the first tube in the amplifiers signal path.
Dialling in more BOOST will have the effect of pushing a clean amp into warm tube clipping or naturally
compressing an already clipping amplifier.
3
3 4
- Indicates that the amplifier is powered up and ready to play.
5
7
6
USER MANUAL
10
9
8
www.laney.co.uk