Table of Contents
Advertisement
Thermistor Replacement (RBF30,
RBF36, RBF36P, RBF42)
Tools Required: Phillips head screwdriver
1. Follow the steps of 'Preparing for Service" on page 8.
2. Remove the 2 hex head screws on either side of the
controls and the 4 hex head screws (12 screws total)
along each side of the panel and gently lower the
internal assembly. (Figure 4)
3. Disconnect the two main wire connectors - one on each
side of the unit.
4. Disconnect the hanging straps at the front, ensuring
that you support the entire assembly, and lift the back
of the assembly up and off of the hook at the back. At
this point you should be able to gently set the assembly
on the surface in front of the unit to replace the
thermistor.
5. Locate the thermistor and tie wrap securing it to the
standoff. (Figure 4)
6. Trace the wire from the thermistor to the main control
board and disconnect the wire, noting the location on
the board.
7. Run the wire from the thermistor, following the same
path as the wire that was removed. Attach the new wire
to the board.
8. Install the replacement thermistor and secure.
9. Reassemble the remainder of the firebox in reverse
order from the instructions above.
Top Front Lights Replacement
Tools Required: Phillips head screwdriver
1. Follow the steps of 'Preparing for Service" on page 8.
2. Remove the 2 hex head screws on either side of the
controls and the 4 hex head screws (12 screws total)
along each side of the panel and gently lower the
internal assembly. (Figure 4)
3. Locate the defective front top light assembly. From the
backside of the standoff press the center out to release
the center pin and remove the light assembly. (Figure
4)
4. Disconnect the connection on each end, noting which
end is labeled "IN" and which is labeled "OUT".
5. Orient and place the new LED strip, using the
previously removed pin to secure it to the top panel.
6. Reassemble the remainder of the firebox in reverse
order from the instructions above.
Rear Top Lights Replacement
Tools Required: Phillips head screwdriver
Needle nose pliers
1. Follow the steps of 'Preparing for Service" on page 8.
2. Locate the rear top light assembly and use the pliers
to pinch the back of the standoffs while pulling the LED
away to release the light assembly.
3. Disconnect the connection.
4. Properly orient the LED strip, ensuring that the end
labeled "IN" is toward the left, so that it can receive the
connection.
5. Reassemble the remainder of the firebox in reverse
order from the instructions above.
17
Hide quick links:
Advertisement
Table of Contents
