Table of Contents
Advertisement
Icon
Function
F
360
Light
o
G
Timer
Light
H
Sensor
I
Brightness
J
Heat Mode
K
Temp Up
Change Fahrenheit (
F)
°
to Celsius (
C)
°
Heat Enable
Heat Disable
L
Heat
Control Lock
Control Unlock
6
Description
Press multiple times to change the LEDs on the sides and back of the unit from
Midnight mode to white to yellow to red. (The middle segment on the display will
change through 0 - 3 respectively. This feature is active only when the Flame is
ON.)
Press multiple times to change the sleeper timer in 0.5 hr increments from 0.5 hr
to 8.0 hr before turning off. The remaining time on the sleep timer displays.
Press to activate the ambient light sensor (ALS ON). Press again to turn the
sensor off (ALS OFF).
!
NOTE: The light sensor will adjust the brightness of the fireplace based on
the ambient light in the room.
Press to change the LED lights from High to Low. (The last segment on the
display will change from "H" to "L") The Realog
heater is ON and the flame effect is Off.
!
NOTE: When the Light Sensor is activated, High and Low flickering
brightness settings are also available (Flashing "H" and "L").
Press the multiple time to toggle through the heat modes (Normal, Eco and
Boost). Normal is indicated with a Nor on the display, ECO is indicate by an Eco
on the display and Boost is indicate by a b20 on the display. In boost mode, a
time is set initial for 20 minutes and the display will indicate b19, b18, etc., as the
time counts down. This is shown by pressing the heat mode button.
Press multiple time to raise the heater temperature in 1
Displays current temperature; highest temperature is 99
active whenever the heat is enabled.
Press both Temp+ (
Hold both Heat (
) and Temp– (
displays on the screen.
Hold both Heat (
) and Temp– (
temperature is adjusted "---" displays on the screen.
• Heat On
Press to turn heat On (indicated by 1 short beep and the icon appearing on the
display). Displays current heater temperature setting. Use the Temp Up/Down
icon to change the heater temperature setting.
• Heat Off
Press to turn heat Off (indicated by 1 short beep).
!
NOTE: After the heater is switched off, the fan will continue on for 60
seconds before turning off.
Hold both Temp– (
) and Brightness (
disable the manual controls.
Hold both Temp– (
) and Brightness (
the manual controls.
TM
) and Temp– (
) on the unit.
), on the unit, for 2 seconds. Temperature
), on the unit, for 2 seconds, when
), on the unit, for 2 seconds to
), on the unit, for 2 seconds to enable
LEDs remain On when the
F (1
C) increments.
°
°
F (37
C). This feature is
°
°
www.dimplex.com
Hide quick links:
Advertisement
Table of Contents
