Table of Contents
Advertisement
brackets to the mantel.
4. Remove the front glass and set aside in a safe place.
5. Pull the front edge of the plastic Ember Bed or plastic
grate up and forward until the rear tab releases from
the ledge located at the bottom of the Partially Reflect-
ive Panel. (Figure 7)
! IMPORTANT: Only handle the Log Set by the Ember
Bed.
! NOTE: Log Set fits tightly into firebox, some force may
be necessary to remove.
6. Reassemble in the reverse order as above.
PARTIALLY REFLECTIVE PANEL
REPLACEMENT
Tools Required: Phillips Head Screwdriver
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights, heating elements and top
panel to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the front glass and set aside in a safe place.
3. Remove the firebox from the back of the mantel by
removing the retaining screws which secure the firebox
brackets to the mantel.
4. Remove the two screws along the back of the unit and
the two on either side along the bottom edge. (Figure 5)
5. Lay the Compact Fireplace on its back.
6. Gently open the bottom panel, laying it on the work sur-
face so that all of the components can easily be seen.
(Figure 6)
7. Remove the two screws on each side that secure the
partially reflective support bracket to the firebox.
8. Remove the partially reflective support bracket.
9. Remove the partially reflective panel by sliding it out of
the side channels towards the bottom.
10. Install the new partially reflective panel.
11. Reassemble in the reverse order as above.
Figure 7
Back
Ledge
Rear
Tab
Log
Ember
Bed
Front
Side Section
Edge
THERMISTOR REPLACEMENT
Tools Required: Phillips Head Screwdriver
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights, heating elements and top
panel to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the front glass and set aside in a safe place.
3. Remove the firebox from the back of the mantel by
removing the retaining screws which secure the firebox
brackets to the mantel.
4. Remove the two screws along the back of the unit and
the two on either side along the bottom edge. (Figure 5)
5. Lay the Compact Fireplace on its back.
6. Gently open the bottom panel, laying it on the work sur-
face so that all of the components can easily be seen.
(Figure 6)
7. Remove the two screws on each side that secure the
partially reflective support bracket to the firebox.
8. Remove the partially reflective support bracket.
9. Remove the partially reflective panel by sliding it out of
the side channels towards the bottom.
10. Locate and release the thermistor from the back panel
by using needle nose pliers to depress the tab on the
mounting standoffs and gently lift the board off.
11. There is one connection located on the display/control
board that may require the board to be removed. This
can be done by removing the two screws on the right
hand side of the unit to remove the display/control
board to remove the connection and replace it with the
new one.
12. Install the new thermistor.
13. Reassemble in the reverse order as above.
11
Advertisement
Table of Contents
