Page 1
IMPORTANT SAFETY INFORMATION: Read this manual first before attempting to install or use the Revillusion Log Set. Always comply with the warnings and ™ safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, visit www.dimplex.com 7214550100R02...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
Welcome Thank you for purchasing a Revillusion™ Log Set by Dimplex. Please use our convenient online registration page to record your model and serial numbers for future reference at: www.dimplex.com/register Model Number MODEL / CAT NO SERIAL NO Serial Number CAUTION: Read all instructions and warnings carefully before starting installation.
Contact ⑬ Always plug the log set directly into Dimplex Technical Service at 1-888- a wall outlet/receptacle. Never use with 346-7539. an extension cord or relocatable power ⑤ Do not use this log set outdoors.
Page 5
IMPORTANT INSTRUCTIONS Special Precautions FCC Compliance WARNING: Remote control contains CAUTION: This unit has been tested a small battery. Keep away from children. and found to comply with the limits for If swallowed, seek medical attention Class B digital device, pursuant to part immediately.
Do must comply with local building codes and not install into an existing fireplace other applicable regulations to reduce the risk of fire, electric shock, or injury to opening that is prone to dampness. persons. www.dimplex.com...
Page 7
Installation Assembly Install the Mirage™ Flame Panel by inserting the bottom edge into the . Place the log set into position. tabs between the back log and grate log assemblies. a. Lift the log set by holding the sides of the heater box for a.
120-volt circuit and has a grounding plug that looks like the plug in the following figure. Make sure that the product is connected to an outlet having the same con figuration as the plug. No adapter should be used with this product. www.dimplex.com...
Operation Manual Control Light The manual controls for the Revillusion Press multiple times to change are located on the right-front leg of the the LEDs on the sides and back log grate. of the unit from white flickering to white solid to Off. (This feature is active only when the flame effect is On.) Brightness...
Page 10
Press to turn heat Off (indicated by 1 long beep). NOTE: After the heater is switched off, the fan will continue on for 60 seconds before turning off. The log LEDs remain On when the heater is ON and the flame effect is Off. www.dimplex.com...
Maintenance General Maintenance Clean Mirage™ Flame Panel Inspect the log set regularly, depending The Mirage™ Flame Panel is cleaned upon conditions, and at a minimum in the factory during the assembly yearly intervals. Remove dust and operation. During shipment, installation, clean the logs, mat, grate, and base as handling, etc., the screen may collect required.
Hawaii, or Alaska are not covered by this limited warranty. Products purchased in these States, What Dimplex will do in the event of a defect provinces, or territories are sold AS IS without In the event a product or part covered by this...
Page 13
Contracts for the Sale of Goods shall not apply • Dimplex will not be responsible for, and the to this limited warranty or the sale of products limited warranty services shall not include, covered by this limited warranty.