ISO DDIN radio provision
1. Remove (2) T-20 Torx screws securing
the a/c vents. (Figure A)
2. Route the hazard switch wiring harness
through the bezel mount, then clip the
mount to the dash. (Figure B)
3. Secure the radio brackets to the radio
using screws supplied with the radio.
(Figure C)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
6
KIT ASSEMBLY
(Figure A)
(Figure B)
(Figure C)
|
386.257.1187
MetraOnline.com