Advertisement
ISO DIN radio provision with pocket
1. Remove (2) T-20 Torx screws securing
the a/c vents. (Figure A)
2. Route the hazard switch wiring harness
through the bezel mount, then clip the
mount to the dash. (Figure B)
4
KIT ASSEMBLY
(Figure A)
(Figure B)
3. Secure the pocket to the radio brackets
using (4) Phillips screws provided.
(Figure C)
4. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
5. Slide the radio into the bracket/pocket
assembly, then secure using screws
supplied with the radio. (Figure D)
(Figure C)
(Figure D)
|
386.257.1187
MetraOnline.com
Advertisement
