Download Print this page

Metra Electronics 99-9009 Installation Instructions Manual

Car radio kit

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS FOR PART 99-9009
VW Touareg/Touareg2
99-9009
KIT FEATURES
• DIN Head Unit Provision with Pocket
• ISO DIN Head Unit Provision with Pocket
KIT COMPONENTS
A) Radio Housing • B) ISO Snap-In Brackets • C) Trim Plate
A
C
1-800-221-0932
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
APPLICATIONS
2004-2010
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Wiring Harness:
B
• 70- 9003 - VW Toureg Harness 2004-up
Antenna Adapter:
• 40-EU55 Amplified VW Antenna Adapter
TOOLS REQUIRED:
86-9001 Radio Removal Tools (2 sets) • Flat Blade Screwdriver
www.metraonline.com

Advertisement

loading

Summary of Contents for Metra Electronics 99-9009

  • Page 1 INSTALLATION INSTRUCTIONS FOR PART 99-9009 VW Touareg/Touareg2 99-9009 KIT FEATURES • DIN Head Unit Provision with Pocket • ISO DIN Head Unit Provision with Pocket KIT COMPONENTS A) Radio Housing • B) ISO Snap-In Brackets • C) Trim Plate 86-9001 Radio Removal Tools (2 sets) • Flat Blade Screwdriver 1-800-221-0932 ©...
  • Page 2 99-9009 Dash Disassembly ....... . . 1 Kit Assembly ........2-3 Final Assembly .
  • Page 3 99-9009 2004-2010 VW TOUAREG Disconnect the negative battery terminal to prevent an accidental short circuit. Insert the long ends of the 86-9001 into the slots on the factory radio and pull out to remove. (Figure A) NOTE: Flat edge of key should point outward.
  • Page 4: Din Head Unit Provisions

    99-9009 DIN HEAD UNIT PROVISIONS Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. (Figure A) Slide the aftermarket head unit into the cage and secure. (Figure B)
  • Page 5: Iso Din Head Unit Provisions

    Mount the ISO Brackets to the head unit with the screws supplied with the unit. (Figure A) Slide the head unit into the radio opening until the side clips engage. (Figure B) Snap the Trim plate into the Radio Housing. (Figure B) 99-9009...
  • Page 6 99-9009 Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making the connections as shown. (Isolate and indi- vidually tape off the ends of any unused wires to prevent electrical short circuit) Re-connect the negative battery terminal and test the unit for proper operation.
  • Page 7 99-9009...
  • Page 8 INST99-9009 1-800-221-0932 www.metraonline.com Rev. 04-27-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-9009...