Table of Contents
Advertisement
Should your unit fail to operate properly, check that there is power to the unit and that the hopper contains ice. If
the unit still does not dispense, check the following chart under the appropriate symptoms to aid in locating the
defect.
BLOWN FUSE OR CIRCUIT BREAKER.
GATE DOES NOT OPEN. AGITATOR DOES NOT TURN.
GATE DOES NOT OPEN OR IS SLUGGISH. AGITATOR
TURNS.
GATE OPENS, AGITATOR DOES NOT TURN.
ICE DISPENSES CONTINUOUSLY.
SLUSHY ICE, WATER IN HOPPER.
91718
TROUBLESHOOTING
Trouble
Probable Cause
A.
Short circuit in wiring.
B.
Defective gate solenoid.
C.
Defective agitator motor.
A.
No power.
B.
Bent depressor plate (does not actuate
switch).
C.
Defective dispensing switch.
A.
Defective gate solenoid.
B.
Weak gate spring.
C.
Excessive pressure against gate slide.
A.
Ice solidified in hopper.
B.
Defective agitator motor.
C.
Defective capacitor (D90 only).
A.
Stuck or bent depressor plate (does not
release switch).
B.
Defective dispensing switch.
C.
Improper switch installation.
A.
Blocked drain.
B.
Unit not level.
C.
Poor ice quality due to water quality or
ice maker problems.
6
Advertisement
Table of Contents
