Controller Configuration Authentication - Banner Sure Cross DXM1200-Bx Instruction Manual

4. Click on Send Authentication.
The controller must be connected to the PC for this operation to succeed.
The data transmits directly to the DXM1200's non-volatile memory. If successful, a pop-up window appears, asking
to reboot the device.
5. Select Yes to reboot the device.
Set the Web Services to Use Authentication
1. At the Banner Connected Data Solutions by Sensonix website, go to Settings > Sites.
2. To edit the site settings, click Edit on the line of the site name.
At the bottom of the pop-up window is a checkbox to enable authentication/validation.
3. Enter the same username and password as used in the DXM Configuration Software. The username and password
do not need to be a defined user within the Banner Connected Data Solutions by Sensonix website.

8.2.2 Controller Configuration Authentication

The DXM1200 can be programmed to allow changes to the configuration files only with proper authentication by setting up
a password on the Settings > Administration screen in the DXM Configuration Software.
With the DXM1200 connected to the PC, click Get Device Status. The DXM1200 status displays next to the button.
Use the DXM Configuration Software to:
• Set the Admin Password
• Change the Admin Password
• Remove the Admin Password
To change or remove an admin password, the current password must be supplied. The DXM1200 must be connected to the
PC to change the administration password.
Figure 20. Settings > Sites screen of the Banner CDS website
Figure 21. Settings > Administration screen
www.bannerengineering.com - Tel: + 1 888 373 6767
®
Sure Cross DXM1200-Bx Wireless Controller
45