Table of Contents
Advertisement
®
Sure Cross
DXM1200-Bx Wireless Controller
2. Use the Up or Down arrows to select the Node number (DX80 network) or Modbus Slave ID (MultiHop network).
Press ENTER to run the site survey with that Node or slave.
The site survey results display as green, yellow, red, and missed packets. Green indicates the highest signal strength, then
yellow, and red. Missed packets were not received.
2.1.3 Set the IP Address
Change the IP address of the DXM1200-B1R1 to connect to a local area network, Modbus TCP/IP host controller, or
EtherNet/IP host controller.
Equipment needed:
•
DXM1200-B1R1 Wireless Controller
There are two ways to set the IP address: using the DXM's LCD menu or using the DXM Configuration Software to change
the XML file.
IP addresses entered into the LCD menu system override the IP addresses in the XML configuration files. To use the IP
addresses set in the XML configuration file, clear the IP addresses from the menu system.
1. On the DXM, use the arrows and move to the System Config menu. Press Enter.
2. Use the arrow keys to select the Ethernet menu. Press Enter.
3. Use the arrow keys to select IP. Press Enter.
The octet of the IP address displays (for example, 192.168.10.1).
4. Use the up and down arrows to change the IP address. Press Enter to move to the next octet.
5. Press Enter on the final octet to accept the changes.
6. Cycle power to the DXM1200.
The changes are saved on the DXM1200 and the new IP address will be used.
Use this same procedures to set the subnet mask (SN) and default gateway (GW) to match your network requirements.
2.2 Configuration Instructions
2.2.1 Configuring the DXM1200 Controller
Configure the DXM1200 using the configuration software.
The DXM Configuration Software allows the user to define parameters for the DXM1200, then saves the configuration in an
XML file on the PC.
12
DXM Configuration Software
Local Registers
Register Mapping
Action Rules
Scheduler
Script Basic
System
Register
Settings
View Utility
XML Config File
Figure 5. DXM Configuration Software
www.bannerengineering.com - Tel: + 1 888 373 6767
Internal Micro
USB
Ethernet
Advertisement
Table of Contents
