Ism Radio; System Config - Banner Sure Cross DXM1200-Bx Instruction Manual

6.3 ISM Radio

The ISM Radio menu allows the user to view the Modbus ID of the internal ISM radio, enter binding mode, or run a site
survey. This top-level ISM Radio menu is different from the System Config > ISM Radio submenu.
The first option under the ISM Radio menu only displays the type of radio in the DXM1200 (MultiHop or DX80 Star) and the
Modbus ID of the radio. To change the ISM Radio Modbus ID refer to the System menu.
Select Binding to enter binding mode or select Site Survey to run a site survey.
ISM Radio MultiHop/DX80 ID
Binding
Site Survey
Binding— All ISM radio devices must be bound to the internal Gateway/master device before the DXM1200 can access the
wireless devices. The first submenu under binding allows the user to set the wireless address of the device to bind with.
This is required to bind with wireless devices that do not have rotary dials (for example: M-GAGEs, ultrasonic sensors, and
Q45 devices). See Binding and Conducting a Site Survey with the ISM Radio
particular device, refer to the individual datasheet.
Site Survey—After creating a wireless network using the binding process, run a site survey on each device to see the link
quality. See Conduct a Site Survey

6.4 System Config

Use the System Config menu to set DXM1200 system parameters.
System Config ISM Radio
Ethernet
Provision Cell
DXM Modbus ID: xxx
LCD Contrast: xx
Restart
The System Config submenus are:
Bind to > 1
Node/Modbus ID > 1
Please Wait...
Site Survey results OR Failed to start Site Survey
on p. 11.
DX80 ID: x
Auto Detect Radio
Advanced Options
Max Node Count: xx
Binding #: xxxxxx
RF Ctrl: Dip 1.00W
DHCP
IP:
SN:
GW:
Reset
www.bannerengineering.com - Tel: + 1 888 373 6767
®
Sure Cross
↑ ↓
to change the value
to accept
ENTER
to return to the previous menu
BACK
on p. 10. For more information on binding a
New ISM Modbus ID: x
Radio Detected Type: DX80
ID: 1
Ref Type: DX80
Ref Modbus ID: x
New ISM Max Nodes: xx
New ISM Binding Code: xxxxxx
Update DHCP Mode
After making changes to the
Ethernet settings, restart the DXM.
Update IP Address
Update SN
Update GW Address
Resets Ethernet parameters
to xml defaults.
↑ ↓
ENTER
BACK
DXM1200-Bx Wireless Controller
to change the value
to accept
to return to the previous menu
35