Troubleshooting - Stiga BL 40 Li Operator's Manual

13. TROUBLESHOOTING

PROBLEM
1. The machine does not
start when the throttle
control is activated
2. The motor shuts
down whilst working
3. The rotor rotates, but
the air does not come
out from the blower tube
4. Excessive noise and/or
vibration is experienced
whilst working
5. The machine gives off
smoke whilst working
6. Battery power
reserve is low
7. The battery charger
is not recharging
the battery
If problems persist after implementing the solution, contact your Dealer.
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Faulty throttle control or
damaged blower
Battery is not inserted correctly
Low battery
Blocked or clogged blower tube
Loose or damaged parts
Damaged blower.
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
Battery is not correctly inserted
in the battery charger
Unsuitable environmental conditions
Dirty contacts
The battery charger is not energised
Faulty battery charger
Make sure that the battery is
inserted correctly (para. 7.2.3)
Check the battery status and recharge
if necessary (para. 7.2.2)
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Make sure that the battery is
inserted correctly (para. 7.2.3)
Check the battery status and recharge
if necessary. (para. 7.2.2)
Stop the machine,
and remove any obstructions.
Turn off the machine
–
inspect for damage;
–
check for and tighten any loose parts;
–
have any damaged parts replaced
or repaired with parts having
equivalent specifications.
Do not use the machine. Immediately
turn off the machine,
and contact a service centre.
Optimise operations
(para. 7.2.1)
Use a second battery or extended
battery (para. 14.1)
Purchase a new battery
Check it is correctly inserted (para. 7.2.2)
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the battery/
battery charger manual
EN - 13
SOLUTION
remove the battery
remove the battery
remove the battery and:
remove the battery