Antenna Assembly - Sony Ericsson P910a Working Instruction, Mechanical

4.19 Antenna Assembly

Tools:
•
•
NOTE!
•
Perform the steps of "Disassembly" section before proceeding.
NOTE!
1. Remove the two M1.4 x 4MM screws that hold
the antenna using a torque driver with a JCIS
No. 0 bit.
2. Using the tip of one side of a pair of blunt tip
tweezers, pry between the back cover and the
antenna assembly at one of the antenna
assembly's board latches so that that side of the
antenna assembly becomes free from its catch
feature in the back cover.
3. Once one side of the antenna assembly is free,
repeat the same procedure at the antenna
assembly's other board latch.
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Torque screwdriver
Nylon pointer
Whenever the phrase "pry tool" is used, a nylon pointer, an orange stick, or a front
opening tool may be used, depending on the user's preference.
Be careful not to damage the antenna
when removing the antenna assembly.
•
Style 2A ESD-safe tweezers (Blunt Tip)
•
JCIS No. 0 bit
•
Orange stick
Step-by-Step Instructions
Working Instruction, Mechanical
•
Front opening tool
46(62)