Vibrator; Rear Speaker, Holder, And Cloth; Audio Jack And Audio Jack Cover; Microphone Assembly And Microphone Cloth - Sony Ericsson P910a Working Instruction, Mechanical

4.14 Vibrator

The removal and installation of this part is covered in the "Back Cover" section of this document.
Assume that this part is being replaced instead of the back cover. A new part should be used in
the place of the old part when reassembling. Limit the amount of disassembly to only that which
is needed to replace this part.

4.15 Rear Speaker, Holder, and Cloth

The removal and installation of these parts is covered in the "Back Cover" section of this
document. Replace the needed part instead of the back cover when performing instructions of
the back cover section. A new part should be used in the place of the old part when reassembling.
Limit the amount of disassembly to only that which is needed to remove the part that is being
replaced.

4.16 Audio Jack and Audio Jack Cover

The removal and installation of these parts is covered in the "Back Cover" section of this
document. Replace the needed part instead of the back cover when performing instructions of
the back cover section. A new part should be used in the place of the old part when reassembling.
Limit the amount of disassembly to only that which is needed to remove the part that is being
replaced.

4.17 Microphone Assembly and Microphone Cloth

Tools:
•
•
NOTE!
•
Perform the steps of "Disassembly" section before proceeding.
NOTE!
NOTE!
1. Remove the microphone assembly from the
microphone cavity in the back cover.
3/00021-1/FEA 209 544/90 A

Sony Ericsson Mobile Communications AB
Style 2A ESD-safe tweezers (Blunt Tip)
Front opening tool
Whenever the phrase "pry tool" is used, a nylon pointer, an orange stick, or a front
opening tool may be used, depending on the user's preference.
Avoid damaging or contaminating the
conductive elastomer when removing or
installing the microphone assembly.
If the conductive elastomer comes off
during the removal of the microphone
assembly, use a new microphone
assembly.
•
•
Step-by-Step Instructions
Working Instruction, Mechanical
Nylon pointer
Orange stick
41(62)