Cutting Height Adjustment (14:G); Rear Accessory Adjustment Control (14:H; 14:I); Rear Accessory Control (14:L); Accessory Lifting Device, Hydraulic (1:G) - Stiga Park 4WD Series Instruction Manual

(Translation of the Original Instructions)
when the engine is running. The unit of me-
asurement is followed by the letter H.
When the hour meter reaches 9999 it re-
turns to zero. After 999 hours, the minutes
count is dropped.
6 13 POWER TAKE-OFF (14:F)
Button to engage / disengage the PTO
(14:F) Press the button to engage / disen-
gage the PTO.

6 14 CUTTING HEIGHT ADJUSTMENT (14:G)

The machine has two buttons for adjusting the
cutting height:
Press to raise the cutting height.
Press to lower the cutting height.
The cutting mean assembly is connected to
the socket (16:A)
6 15 REAR ACCESSORY
CONTROL (14:H; 14:I)
The machine has a control for electrically adjusting
the rear accessory (optional accessory).
The socket (17:B) (optional) for connecting the
accessory is located on the back right-hand side
of the machine.
The button can be used to lift and lower the
rear accessory.

6 16 REAR ACCESSORY CONTROL (14:L)

The machine is designed for use with an electrical
rear accessory.
The socket (17:A) for connecting the accessory
is located on the back right-hand side of the
machine.
Use this button to switch on/off the power
supply to the accessory.
For the rear accessory power rating, please refer
to " 0 TECHNICAL DATA TABLE"
Only use accessories approved by STI-
GA SpA
ENGLISH
ADJUSTMENT
6 17 ACCESSORY
HYDRAULIC (1:G)
The hydraulic accessories lifting device is active
only when the engine is running and pedal (13:A)
is released. The accessories lifting device is con-
trolled by a lever (14:M).
The lever can be in one of the four following
positions:
Floating positions Move the lever to the
most forward position, where it stops At this
point the accessory is lowered to the floa-
ting position. In this position, it is always re-
sting on the ground exerting the same pres-
sure and can follow the profile of the terrain.
Use the floating position when performing
work.
Lowering The accessory is lowered in
a manner which does not depend on its
weight.
Standby position (central) After lifting or
lowering, the lever returns to the standby
position. The accessory holds the position
of the last command executed.
Lifting Move the lever to the furthest back
position until the accessory has reached
the highest position (transport position).
Then release the lever: the accessory re-
mains blocked in the transport position.
6 18 HYDRAULIC CONNECTIONS CONTROL
LEVER (14:O; 14:N) (Mod. 740 IOX)
The two levers (14:O; 14:N:) control the hydraulic
connectors (18:A; 18:B) located on the back left-
hand side of the machine.
To get to the connectors, remove the safety guard
(18:C) secured in place with a screw.
Connect the accessories hydraulic lines to a pair
of connectors AUX 1 or AUX2 (18).
Both levers have three positions:
Forward/Back: move the lever in either of these
directions to move the connected accessory in the
relative direction (please refer to the instructions
supplied with the accessory).
Central position: standby.
To activate the accessory, proceed as follows:
• Move the lever forward / back just enough to
obtain the required movement.
• Release the lever to lock the accessory in the
selected position, the lever automatically re-
turns to the standby position.
EN
LIFTING DEVICE,
15