Setting Address Of Panel Bus I/O Modules; Setting I/O Bus Switch - Honeywell Centraline LION Installation & Commissioning Instructions

LION System

Setting Address of Panel Bus I/O Modules

During engineering, each Panel Bus I/O module is assigned
its own unique address. For the sake of clarity for
maintenance personnel, it is recommended that you
address the Panel Bus I/O modules in ascending order
0 through F.
Hex switch 0 1
Address 01 02
Hex switch 8 9
Address 09 10
Table 24 HEX switch settings and addresses
Use the rotary HEX switch to set the address to the one
►
already defined using the engineering tool.
LOCK
Fig. 37 HEX switch location
NOTE: If the HEX switch is changed, the Panel Bus I/O
module will revert to its default configuration.
NOTE: With L W Bus I/O modules, the HEX
ON ORKS
switch is without function.
2 3 4 5 6 7
03 04 05 06 07 08
A B C D E F
11 12 13 14 15 16
4
4

Setting I/O Bus Switch

Set the I/O Bus switch S2 of the CLLIONLC01 depending
►
on the modules connected to terminals 71 ... 78 and the
desired communication as follows:
Communication
L W Bus
ON ORKS
only
Panel Bus and
L W Bus
ON ORKS
Table 25 I/O Bus switch settings
S2
Panel
LO N
I/O Bus
Fig. 38 S2 I/O Bus switch
27
Wiring and Setting Up the System
S2 setting Terminals
LON 71 ... 74 L W
ON
75 ... 78 L W
ON
11 ... 14 L W
ON
Panel 71 ... 74 Panel Bus
75 ... 78 Panel Bus
11 ... 14 L W
ON
EN1Z-0921GE51 R0315
Bus
ORKS
Bus
ORKS
Bus
ORKS
Bus
ORKS